Hi there , This thread is inactive for more than 60 days. New postings Here's unlikely to become noticed or responded to by other users. For greater visibility, look at Commencing A New Thread.

They claim "Polyethylene is usually a one hundred% recyclable material, meaning that AQUALOON has added an ecological component to its know-how", so once more we're going to substitute a a hundred% organic product by using a petrochemical item?

templehb said: I used to be handling an algae problem because I couldn't keep my FC right away. I stunned for almost each week to test to carry it right away and assumed it was looked after. Seemingly it wasn't for the reason that Again the FC will not likely keep right away. But I just made use of an AA treatment four days back and was explained to I couldn't shock for 2 weeks.

I see your PoolMath logs are linked to your Discussion board account, but there are no entries for the last two years. Use PoolMath to put up your success.

Mike1162 claimed: I just viewed a movie on youtube that demonstrates them in the laundry bag getting put into a washing machine. Do the directions point out this? Click on to increase...

You mentioned that it wasn’t incredibly foamy, i suspect It's because the surfactants in the solution experienced alot to break down. Considerably less grime = more foam & vice versa.

Also make sure you have some sanitizer within the h2o given that you might want to touch the water to clean (I'd personally go slam stage) Click to develop...

From working day just one (after we bought the house a month ago), it (Intellichlor/ScreenLogic) hasn't indicated salt level (on my ScreenLogic, It is constantly shown ZERO). But no lights about the chlorinator ended up indicating very low salt or another issues (at first). My chlorine level was floating about 10ppm and I had my chlorinator established to 0% but it absolutely was Keeping at nine-10ppm continuously (instead of lowering after some time as I'd personally foresee). So all alongside I've been think the chlorinator was developing [a little bit] chlorine While I'd it established to 0%. But getting new to your SWG pools plus the Pentair tools, I assumed I would hold out and see what it did. Well, about a 7 days ago I found which the red mild (over the IC40) was on (wasn't in advance of) for your Cold Water Cutoff. I went in to your diagnostic mode of the device and it reads forty% (4000 hrs) on the daily life/utilization and when I'd strike the up button once more to check out what temp it absolutely was looking through, no lights would arrive on for temp. Right after a few days (from the Pink Light to the Cold Water Cutoff), my chlorine degrees began dropping (so it had been definitely not generating chlorine any more). So just after some research, I was sure it had been a the move/temp sensor. chlorwasser allergie I bought two of them figuring They are really regarded to head out and I would've a spare. I changed the sensor and originally, on startup, I observed a salt studying on my ScreenLogic cell phone App of 4600 (my real salt amount is about 3500-3600).

Changing your pH may also adjust your TA. End users should be incredibly aware in their CSI when their pH is at the best of base on the instructed ranges.

Incorporate by fat or by volume of stabilizer or incorporate of liquid stabilizer. To reduced CYA you substitute from the water with new h2o. Observe: It usually takes reliable stabilizer 24 to 48 hours to dissolve. Salt

Yep, exactly what it says, a crash study course from the pool care Essentials. A simple, quick study to obtain you started on Understanding the one hundred and one of pool care. Read much more

Replaced the board and new serial cable, exact random shut down. Replaced the drive unit as well as new upper board. Exact same concern. What is going on below as not anything to interchange? Is there a compatability problem With all the more mature intellitouch i7 as Pentair denies this?

I think you can find not that lots of Intelliflo3 pumps linked to IntelliTouch units. New pumps are being put in with EasyTouch or IntelliCenter systems.

I will publish these tomorrow. My Youngsters couldn't believe that the difference. Many thanks for every one of the input. I could only discover Metal Free to employ to be a sequestrant.